 |
You are here:
Krono.com | Kronotex | Floor technology
|
|
|
|
|
|
Basic parameters of Kronotex Laminate floors
|
|
|
|
|
|
1. The installation should be performed at an ambient temperature of at least
18° C, a ground temperature of at least 15° C and relative humidity of 50% (minimum) and 75% (maximum). Please do not aerate the space during installation.
2. For optical reasons, Kronotex panels and planks should always be laid lengthways in relation to the principle light source.
3. Prior to installation, calculate the width of the final row of planks: they should not be less than 5 mm wide. If necessary, cut the first row of planks accordingly.
4. Kronotex flooring is laid using a floating system, which means that the flooring is not glued, nailed, attached to fixed to the subfloor in any way. Adhesive is applied to the tongue-and-groove joints only. After laying the floor, attach mouldings directly to the wall only, and not to the flooring!
5. When putting planks in place, never hammer directly on the plank tongue. Use an appropriate tapping block instead. In doing so, make certain that the tapping block is placed squarely against the tongue and that the latter is seated properly in the groove of the tapping block.
6. Be sure to perform the installation exactly as described in the instructions. No claims will be honoured if the procedure described therein is deviated from. If any problems arise, change the manner of installation or interrupt the procedure altogether and contact your supplier.
|
|
|
|
|
|
|
;)
